CKDIST(1) BSD General Commands Manual CKDIST(1) NAME ckdist — check software distributions SYNOPSIS ckdist [-airsx] [-d dir] [-n name] [-t type] file ... DESCRIPTION The ckdist utility reads “checksum” files (which are assumed to specify components of a software distribution) and verifies the integrity of the distribution by validating the checksum of each component file. Both MD5 (128-bit “message digest”) and .inf (32-bit CRC) checksum formats are supported. The file operands may refer to regular files or to directories. Regular files named md5, or which have an .md5 or an .inf extension, are assumed to be of the implied type, otherwise format is determined from content. If a directory is specified, it is searched for appropriately-named files only. The options are as follows: -a Report on all distribution components, not just those in respect of which errors are detected. -i Ignore missing distribution components. -r Search specified directories recursively. -s Suppress complaints about inaccessible checksum files and directories. -x Verify the existence of distribution components (and also check sizes, in the case of .inf files), but omit the more time-consuming step of actually computing and com‐ paring checksums. -d dir Look for distribution components in the directory dir. -n name Access distribution components using the filename name. When accessing .inf file components, append the appropri‐ ate extension to the filename. -t type Assume that all specified checksum files are of the for‐ mat type, and search directories only for files in this format (where type is either md5 or inf). EXIT STATUS The ckdist utility exits with one of the following values: 0 No errors were detected. 1 Errors were found in a distribution. 2 Usage errors, inaccessible input files, or other system errors were encountered. SEE ALSO cksum(1), md5(1) NOTES Both BSD and DOS versions of ckdist are available. BSD January 20, 1997 BSD